Kippzonen CFR Calibration Facility Instrukcja Użytkownika Pobierz pdf (Strona 10)

CFR manual

Step 5 Connect the red and black signal measurement cables to either the back or front input terminals of

the voltmeter and to the signal output terminals near the lamp pillar.

figure 5 Signal cables between voltmeter and signal output terminals

Step 6 The installation will be complete when the mains power cord is connected to an AC power outlet.

The lamp of the 230 VAC / 50 Hz Calibration Facility the lamp can be turned on and off using the switch on

the power strip.

Finally the correct lamp height should be determined by measuring the irradiance with a reference

pyranometer at the left or right position of the turntable. Adjust the lamp height such that the irradiance

should be in the range 500 – 600 W/m

figure 6 Complete calibration facility

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

Brak uwag

Kippzonen CFR Calibration Facility Instrukcja Użytkownika Strona 10